EP Module needed!

 
Post new topic   Reply to topic    www.cadlink.com Forum Index -> EngraveLab / ProfileLab discussion
View previous topic :: View next topic  
Author Message
Bolt



Joined: 20 Dec 2005
Posts: 52
Location: Harrisburg, Pa

PostPosted: Thu Apr 16, 2009 9:58 pm    Post subject: EP Module needed! Reply with quote

I thought my engravelab was not working properly. Now I realize my EP module took a crap. I need a good EP module or a lead to get mine fixed. Call anytime 717-497-3329 or PM me
_________________
Bob
http://www.boltsengraving.com
Photos: http://imageevent.com/bolt/engraver
New Hermes Vanguard 4000, 7200, + looking for another 7200
Frank Droog is the man!
Back to top
View user's profile Send private message Send e-mail
frankd
CADlink Employee
CADlink Employee


Joined: 09 Aug 2005
Posts: 1234

PostPosted: Thu Apr 23, 2009 7:46 am    Post subject: Reply with quote

Are you sure the EP is busted and its not just a setting on the controller.
I thought you said it engraves but acts up just at the end of the job.
Back to top
View user's profile Send private message
Bolt



Joined: 20 Dec 2005
Posts: 52
Location: Harrisburg, Pa

PostPosted: Sun May 31, 2009 10:11 am    Post subject: Reply with quote

Found another EP module. Engraver has been running great with the new one! Sent the old one to Quality One to go over and now I have that old one on e-bay for sale.
_________________
Bob
http://www.boltsengraving.com
Photos: http://imageevent.com/bolt/engraver
New Hermes Vanguard 4000, 7200, + looking for another 7200
Frank Droog is the man!
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    www.cadlink.com Forum Index -> EngraveLab / ProfileLab discussion All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group