ROLAND CROP MARKS CUTTING ISSUE

 
Post new topic   Reply to topic    www.cadlink.com Forum Index -> Printing / Output
View previous topic :: View next topic  
Author Message
tims



Joined: 09 May 2007
Posts: 16
PostPosted: Thu May 24, 2012 4:34 pm    Post subject: ROLAND CROP MARKS CUTTING ISSUE Reply with quote
IN SIGNLAB 9...AFTER I PRINT AND LAMINATE (I'M USING A ROLAND 540V PRINTER). THE CONTOUR CUTS WILL ONLY CUT THE TOP, RIGHT SIDE, AND THE BOTTOM. THE INITIAL LEFT SIDE CONTOUR CUT DOES NOT CUT.

I'M LOOKING FOR AN ADJUSTMENT SETTING IN SIGNLAB THAT CAN CREATE MORE ROOM BETWEEN THE CROP MARKS AND THE IMAGE. THE DISTANCE IS A FRACTION OF A AN INCH.

THANKS
Back to top
View user's profile Send private message
frankd
CADlink Employee
CADlink Employee


Joined: 09 Aug 2005
Posts: 1134
PostPosted: Fri May 25, 2012 12:05 pm    Post subject: Reply with quote
Couldnt you go to Queue/Properties/Media Setup and add Top and Left margin values
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    www.cadlink.com Forum Index -> Printing / Output All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group