signlab 9.1& virtual prod. manger question

[ChrisAlan]

Since last time i was here, I has got sl 9, and updated to 9.1.

I has a question about the output part in the vpm..

what I not Understand is: I make a file, and sending it to the vpm, without problems.

Sending the work to my gerber edge 2 is also fine from the vpm, but than i has printed what should be printed with colour, the edge than slewe the media back to where i started, and than goes offline.( it print it, than goes back )

I had wanted, if possible to make it stop after the print, and where it was, without going back to where it started on my media, as i print one page, and than next one and therefore has to manually slewe it back where it stoped to print. Some of my workfiles do not want to take the option of make copies in the vpm, so therefore i has to use the print page x times option, so it`s a bit work to do that all the time, so where can i adjust that ? Had been great if it was a solution on this.

[frankd]

Can you not go to Queue/Properties/Print Mode Overrides/Printer Options.
Put a checkmark in Change Default Printer Options and change Rewind to OFF

[ChrisAlan]

thanks for the reply. I had that changed to off, and has tested that , but it still happens, but not if i use the other option for copys..