remove registration marks in signlab 9

 
Post new topic   Reply to topic    www.cadlink.com Forum Index -> Printing / Output
View previous topic :: View next topic  
Author Message
trippingbillie22



Joined: 08 May 2006
Posts: 1
PostPosted: Thu May 31, 2012 2:21 am    Post subject: remove registration marks in signlab 9 Reply with quote
I've been using Signlab Print and Cut 9.0 for a while now. Every print that I do through the VPM, whether it has a contour cut file or not, prints with registration marks in the corners. This effectively kills and inch of printable surface that I can utilize. Does anyone know how to shut off the registration marks when they are not needed? I have gone through all of the option menus and can't seem to find anything. Any ideas would be greatly appreciated !
Back to top
View user's profile Send private message
frankd
CADlink Employee
CADlink Employee


Joined: 09 Aug 2005
Posts: 1134
PostPosted: Thu May 31, 2012 9:04 am    Post subject: Reply with quote
In VPM, go to Queue/Properties/Cutter/Registration Marks, and change it to Disable.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    www.cadlink.com Forum Index -> Printing / Output All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group