CADlink forum

Welcome, Guest
Username: Password: Remember me

CADlink, leading developers for sign making, engraving, inkjet film, 2D, 3D routing CNC machines software

TOPIC: Meistegram / H-Square controller problems.

Meistegram / H-Square controller problems. 10 months 3 weeks ago #5374

I'm using engravelab trial 9 with a meistegram controller by H-Square. I'm having the following problems,

Engraving machine will
Stop in the middle of engraving (for large tasks and filling in text)
Will only partially fill in text
Will sometimes draw a line from one letter to another instead of raising the cutter and moving to the next letter then lowering again.
After 8000 or more bytes are sent to the controller the alarm light blinks.

Thanks for help in advance !
The administrator has disabled public write access.

PVObanner

Meistegram / H-Square controller problems. 10 months 2 weeks ago #5380

  • frankd
  • frankd's Avatar
  • Offline
  • Administrator
  • Posts: 40
  • Thank you received: 5
  • Karma: 2
The only thing I know that seems to cure Meistergram problems is to set the Length Threshold to 0 in Cut/Tool Options.

Also maybe make sure that in Windows control panel Port Settings , that your baud rate is 2400, parity in None, data bits is 8, stop bits are 2 and handshake is xon/xoff

Outside chance you will need to install a Real serial port instead of a usb to serial adapter.
Last Edit: 10 months 2 weeks ago by frankd.
The administrator has disabled public write access.
Time to create page: 0.049 seconds