Using Engrave Lab with latest version of windows 10, when using my mouse to select center handle of objects to move the object and mouse go all the way to the top of viewable window or out of view. I do not know exactly when this happened, but it was at some point after the Windows 10 update. Selecting any other handle of object act normally. Grid is off, snap to grid is not set (even when I do have it turned on and a very small grid the object jumps to top as described).
Uninstall and re-install does no good. At a loss to explain as nothing (absolutely nothing) has changed.
Even uninstalled everything and installed trial version, results are the same. (mouse change and driver also did not help)
Version 9.1 Rev 1 Build 14581M
(not sure if there is an update or patch for windows 10 that might fix this)
No other programs used for engraving exhibit any behavior like this. Has anyone else had such strange behavior?
The administrator has disabled public write access.
Engrave Lab \ Windows 10 - Problem with mouse
7 months 17 hours ago #6026