CADlink forum

Welcome, Guest
Username: Password: Remember me

CADlink, leading developers for sign making, engraving, inkjet film, 2D, 3D routing CNC machines software

TOPIC: engrave the area that needs to be engraved

engrave the area that needs to be engraved 9 months 2 weeks ago #6029

  • RonR90
  • RonR90's Avatar
  • Offline
  • New Member
  • Posts: 2
  • Karma: 0
Its been buggin me for a while now. Is there a setting in engrave lab that tells the laser to only pass over the area that is supposed to be engraved. I think the setting in RD works is the "independent output" under scan mode.. I would assume Engravelab has this setting too, but I cant find it.... Ex.. I have triangle that is 4" wide at the base..my laser head continually makes a 4" pass even when it gets to the smallest point of the triangle. This makes the job take forever.. Hope my description helps.
Engravelab V9
Boss 1416 60 watt

thanks
Ron R.
The administrator has disabled public write access.

PVObanner

Time to create page: 0.045 seconds