Had to reinstall Engravelab 9, due to a hard drive failure. Running Windows 10 and Boss Laser LS 1630. After a reinstall (with help from Boss Laser), no matter where I put an object on the plate it wants to burn/engrave/cut only in the upper right-hand corner of my Laser (regardless of plate size). For example I can put a star 10 inches down and over but it will still cut engrave in the upper right corner as close to the corner as possible. Any ideas what would be causing this and how I can fix it ?
The administrator has disabled public write access.
Possible engravelab issue
2 months 1 week ago #6263