CADlink forum

Welcome, Guest
Username: Password: Remember me

CADlink, leading developers for sign making, engraving, inkjet film, 2D, 3D routing CNC machines software

TOPIC: New to Version 9..but having problems

New to Version 9..but having problems 3 weeks 6 days ago #6405

  • ipsd
  • ipsd's Avatar
  • Offline
  • New Member
  • Posts: 2
  • Karma: 0
Hello All!
I have been using engrave lab for years...finally decided I needed to upgrade so I downloaded the trial version of 9 to see if I want to upgrade, but I am having a problem. I created a file and sent to my laser. It sends the file, but not to the laser...not sure where it is going! I opened Corel..sent a file and it goes to the laser and does fine. Anyone have any helpful hints? Just to let you all know also, I just installed my laser (finally after 8 hours!) onto a clean install of Windows 7 32 bit as this is the latest windows I can put my LaserPro Explorer 2 on. I am also running Corel 7.
I just want to make sure that I can use the new engrave lab on this computer and with mold vy laser before I send the money to upgrade...the version I was using up to now was 6.1
Thanks to All in advance
The administrator has disabled public write access.

PVObanner

New to Version 9..but having problems 3 weeks 5 days ago #6406

  • ipsd
  • ipsd's Avatar
  • Offline
  • New Member
  • Posts: 2
  • Karma: 0
I figured out the problem and will post in case others have same problem...I changed the setting in printing preferences to print direct to printer (default is spool).
Works great now.
The administrator has disabled public write access.
Time to create page: 0.047 seconds