CADlink forum

By joining our forum you are agreeing to CADlink Technology's privacy policy. You may opt out at any time.

Welcome, Guest
Username: Password: Remember me

CADlink, leading developers for sign making, engraving, inkjet film, 2D, 3D routing CNC machines software

TOPIC: print and cut misaligment in Signlab

print and cut misaligment in Signlab 4 months 1 week ago #6626

This is for Print and Cut with registration marks in Signlab only, No VPM.
Cutters with a registration mark detector may have a slight misalignment problem.
Where the registration mark detector thinks and the knife thinks that 0,0 is may be slightly off.

In most machines, this can be recalibrated on the machine itself.
Find the manual, do some tests and recalibrate.

However, in our Plotter Setup, in Plotter Options, we have a "Adjust Origin" dialog.
This should be available to all Print And Cut Machines.
You can enter values to move the cut data in both X and Y if the cut cut data is slightly off in position but correct in size.
Last Edit: 4 months 1 week ago by frankd.
The administrator has disabled public write access.
Time to create page: 0.039 seconds