his is for Print and Cut with registration marks in VPMN only.
Cutters with a registration mark detector may have a slight misalignment problem.
Where the registration mark detector thinks and the knife thinks that 0,0 is may be slightly off.
In most machines, this can be recalibrated on the machine itself.
Find the manual, do some tests and recalibrate.
Or, in VPM , go to Queue/ Properties/ Cutter/ Cutter options and play with the Adjust Oregin values.
These can be used to slightly move the cut data in any direction.
This assumes the cut data is the correct size but slightly off in either X or Y
The administrator has disabled public write access.