Hi all, I am new to this software and the machining world, running profilelab with a Larken System 60 table. I am trying to make a sign the is essentially a full cut out circle with a name across the centre, if that makes sense. I've attached a picture for reference of the idea but it will be connected to the circle, unlike the picture. I have created it in Profile lab, made my tool path the way that I want it to cut and when I send it, it says 'no objects to cut', I have everything selected properly and I really dont understand what the problem is. Any help with this would be greatly appreciated!
Thanks in advance!!
1:You probably need to click on Machine/Machining Defaults.
In Engraving Defaults, you will see OPTIONS.
Put a checkmark in OutPut Tool Paths.
Another dialog will appear.
Remove the checkmark from Also Cut Contour paths.
Click on OK.
Then click on the APPLY button.
2:Click on Machine/Machining Defaults.
Near the bottom , it will show if you are Machineing Page, Material and Selected.
If you are cutting Material, click on View/ and make sure there is a checkmark beside Show Material Size.
Click on Layout Material size, and make sure it is a hair smaller than you table.
Make sure your entine drawing is inside the material blank size.
3: did you select your objects and go to Machine/Create Tool Path?
Click on View and make sure there is a checkmark deside Show ToolPaths