CADlink forum

Welcome, Guest
Username: Password: Remember me

CADlink, leading developers for sign making, engraving, inkjet film, 2D, 3D routing CNC machines software

TOPIC: Signlab 9 Cut color prompt?

Signlab 9 Cut color prompt? 9 months 2 weeks ago #5479

  • yuned247
  • yuned247's Avatar
  • Offline
  • New Member
  • Posts: 17
  • Karma: 0
How do you make Signlab prompt before cut after selecting color? On the older version I had SL7 it would prompt me after selecting a color before actually cutting. I know there has to be a setting somewhere in SL9 but I cannot seem to remember where it is.
The administrator has disabled public write access.

PVObanner

Signlab 9 Cut color prompt? 9 months 2 weeks ago #5480

  • rayw
  • rayw's Avatar
  • Offline
  • Administrator
  • Posts: 213
  • Thank you received: 50
  • Karma: 6
Go to Cut > Plotting defaults
In the options check "Cut by Color"
You will then see each colour in the design when you go to cut.
The administrator has disabled public write access.
The following user(s) said Thank You: yuned247

Signlab 9 Cut color prompt? 9 months 2 weeks ago #5481

  • yuned247
  • yuned247's Avatar
  • Offline
  • New Member
  • Posts: 17
  • Karma: 0
rayw wrote:
Go to Cut > Plotting defaults
In the options check "Cut by Color"
You will then see each colour in the design when you go to cut.

Thanks rayw!!!
The administrator has disabled public write access.
Time to create page: 0.056 seconds