Has anyone tried this yet. I just upgraded my JV33-130 to a JV150-130 Mimaki Printer. I had to switch to Rasterlink because there are only about a dozen profiles and the default is the only valid one. Since version 5 I have been using the Signlab Rip. I have Signlab 10 Print and Cut. Printing and cutting to my Graphtec Printer are becoming challenging. Will adding the Rasterlink for Mimaki module fix my print and cut problem?
The administrator has disabled public write access.
Signlab for Mimaki interface
10 months 1 week ago #5910