Just got Cutpro 10 from 6.1 which is all I really needed long story.
How do I change the text? in SignLab 6.1 you just "
swiped across the text in text edit then just go to browse pick a different font and it would change it.
Can't seem to figured out how to do this in CutPro 10.
Any one know how to do this? Thanks Bob
The administrator has disabled public write access.
Pretty much the same in Signlab 10, except all is direct on screen rather than in a dialog box.
Double click the text to edit it, then click and hold mouse cursor before first letter and drag across to the right.
You can highlight as much or as little text as you wish.
Clicking in front of the first character and using Shift + End will highlight the entire line, keep holding shift and use down arrow to highlight additional lines below.