CADlink forum

By joining our forum you are agreeing to CADlink Technology's privacy policy. You may opt out at any time.

Welcome, Guest
Username: Password: Remember me

CADlink, leading developers for sign making, engraving, inkjet film, 2D, 3D routing CNC machines software

TOPIC: SignLab 10 auto sheet cut problem

SignLab 10 auto sheet cut problem 10 months 3 weeks ago #6338

Hello, I have a problem where I am using SignLab 10 to send projects to our new HP Latex 356 printer. However every time a job has finished printing the printer does an automatic sheet cut which is to close to our crop marks which prevents our plotter from cutting the job. This is a new issue that has not occurred on our previous Versa works and older version of signlab.

Can anybody please direct me to where I can stop SignLab 10 from automatically sheet cutting after every job?

** As far as I am aware there is no manual option on the printer its self to cause this

Thanks for the time

Dan
The administrator has disabled public write access.

SignLab 10 auto sheet cut problem 10 months 1 week ago #6350

If you select the queue and then go to Queue > Properties > Printmode Overrides > Printer Options, you will see that there is an option for Cutter and that by default is is ON, check the box at the top to allow making changes and set the cutter to OFF. Click OK to save changes.
The administrator has disabled public write access.
Time to create page: 0.041 seconds