CADlink forum

By joining our forum you are agreeing to CADlink Technology's privacy policy. You may opt out at any time.

Welcome, Guest
Username: Password: Remember me

CADlink, leading developers for sign making, engraving, inkjet film, 2D, 3D routing CNC machines software

TOPIC: Signlab stops when cutting

Signlab stops when cutting 3 months 4 weeks ago #6643

My Signlab 9.1 keep freezes and stops sending information to my US Cutter SC2 Series Plotter. If I cut something with very little detail and small in size it will work. But if I cut anything very big. It will start to sending the information and then stop. It won't start back up. The plotter just stops at which ever point it runs out of information. What do I do? I have wasted a ton of material trying to figure this out. Any help would be greatly appreciated. Thanks.
The administrator has disabled public write access.

Signlab stops when cutting 3 months 3 weeks ago #6648

If you go to Cut > Plotting Defaults > Setup > Port, make a screen shot of the window that opens and attach it to your reply, I am not familiar with the cutter, but this might give me some clues.
The administrator has disabled public write access.

Signlab stops when cutting 3 months 3 weeks ago #6649

I attached the screen shot
The administrator has disabled public write access.

Signlab stops when cutting 3 months 2 weeks ago #6661

I'm still having this trouble. Any ideas why?
The administrator has disabled public write access.

Signlab stops when cutting 3 months 2 weeks ago #6664

Do you have a parallel port on your cutter and computer? If yes, try using that. You will have to change your port in that screen shot to LPT.
The administrator has disabled public write access.

Signlab stops when cutting 3 months 3 days ago #6684

Try changing the Flow Control to Xon/Xoff.
The port settings shown here should match the settings on the plotter. Somewhere on the plotter you should be able to find the port settings, look for RS232 settings and match what you find there, with the settings in Signlab.
The administrator has disabled public write access.
Time to create page: 0.048 seconds