when I drag I file into Signlab 10 print and cut the black border is missing. it works fine in Corel draw or AI. I have rebooted Signlab and my computer several times and still the same thing. anybody have any ideas short of reinstalling
There is a chance , very likely, that the border is a thickline.
By default , Signlab strips out thicklines as we cant tell the knife to be eg 0.5 inches wide.
When you import, there is a checkbox in the lower left corner called Thick Lines
Make sure there is a checkmark in there.
This will let you import the thick line and let you print it.
But you then will get a warning if you try to cut it.
We cannot tell the cutter to change the width of the blade.
The administrator has disabled public write access.